Uncategorized

Many garages have a small 6-12” high curb wall around the perimeter. The question is can you epoxy paint that. The answer is yes. But you have to allow for sufficient amount of material to do it. Curb walls are notorious for using up a lot more material than normal. So when you calculate the square footage of the curb wall you should at the very least double it, we like to triple it to be safe, especially if it’s cinder block.

If the size of your garage is 550 square feet, you should not order just one Armor Chip Kit since that is right at the max coverage. You would need to order the Add On Half Kit. With the half kit you will have plenty of material to do your curb wall. If you don’t have a curb wall and your floor size is close to or just over the max coverage, the other option is to purchase the Epoxy Primer. The primer will add an extra layer of epoxy so that you end up with a thicker coating and it also will increase the coverage of the epoxy since it is now going over a sealed surface.

To prep your curb wall you can simply scrub some etching solution on it and rinse well. Prep on the curb wall is not as critical as it is on the floor since you will not be driving or walking on it. You can apply the color flakes to the curb wall by tossing them underhanded at the curb in small quantities. Using a brush is usually the best option to apply the epoxy.
You can do the curb wall first and cut in the floor edges at the same time. We would do a cut in strip of at least 6” on the floor so that you can have at least a 4” strip of wet epoxy without flakes in it. This lets you overlap onto the epoxy without chips in it for a smoother finish when you do the floor.

Topcoating your curb wall is optional. Again since there is not traffic load a topcoat is not necessary. But if you ordered a sufficient amount of product you should have plenty of topcoat on hand. So you might as well go ahead and use all the topcoat.

When ordering epoxy coatings it’s never a good idea to wait to order so that it arrives a day or two before you plan on doing the job. Many times we get calls from customers who placed an order on a Tuesday or Wednesday expecting to do their project that weekend. If you are in the Tri State area in the Northeast that may be fine but if you are on the west coast or thereabouts then that will be an issue. We do our best to get orders out the door as fast as possible but you have to allow sufficient ground delivery time.

Only water based epoxies can be overnighted so none of our epoxies can be overnighted. When planning to epoxy paint your floor allow as much lead time as possible for several reasons. The epoxy has a shelf life of 1 year and the military topcoat has a shelf life of 6 months. So if you order ahead of time the product will be fine when you’re ready to apply. Also during busy season we tend to get back logged on epoxy orders and it could take a couple of extra days for the warehouse to ship out your epoxy, which is the case as of this righting. We have a sizable backlog of epoxy and deck coating orders. Severe weather can delay FedEx deliveries, or FedEx can lose or damage your order.
As a general guideline always allow a week for delivery, if you are on the west coast allow 7-8 business days to be safe. During summer months lead time for our Renew It Deck Coating can stretch out to two weeks due to demand. Ahead of major holidays you should allow an extra week for delivery.

So plan ahead and if you have an urgent situation gives a call at 866-532-3979 and will do the best we can to accommodate you.